Next, adjust the reticle to match the approximate center of the shot group (see Windage and Elevation Adjustment).At your preferred zero distance, fire a three-shot group as precisely as possible.Before shooting, be sure the reticle is in focus (see Reticle Focus Adjustment) Be sure to follow all safe shooting practices.Vortex Strike Eagle 1-6×24 Range Sight-InĪfter bore-sighting the riflescope, select the exact ammunition you intend to use and go to the range for the final sight-in. We suggest using a torque driver to properly mount your riflescope After aligning the reticle, tighten and torque the ring screws down per the manufacturer’s instructions.Use a reticle leveling tool, plumb bob, or an adjustable set of feeler gauges placed between a onepiece base and the flat bottom of the riflescope’s center section for this procedure. Without disturbing the front-back placement, rotate the riflescope until the vertical crosshair exactly matches the vertical axis of the rifle.While viewing through the riflescope in a normal shooting position, slowly slide the riflescope back towards the shooter’s face-paying attention to the field of view.Slide the riflescope as far forward as possible in the rings.Set the riflescope to the middle of its magnification range.Eye Relief and Reticle Alignmentīefore tightening of the scope ring screws, adjust for maximum eye relief to avoid injury from recoil. Consult the ring and base manufacturer for suggested heights. Ring height for Strike Eagle 1–6 x 24 riflescopes will depend on the firearm and mount being used. Note: Vortex Optics recommends not exceeding 18 inch/pounds of torque on the ring screws. The Strike Eagle 1–6 x 24 riflescope requires 30 mm rings. Vortex Strike Eagle 1-6×24 Rings and Basesįollowing the manufacturer’s instructions, mount a high quality base and rings to your firearm. If you are unsure of your abilities, it would be best to use the services of a qualified gunsmith. Although not difficult, the correct steps must be followed. To get the best performance from your Vortex Strike Eagle riflescope, proper mounting is essential. Remove the cap and slide the battery into the slot. A spare battery may be stored inside the windage cap if desired. Remove the battery and replace with a new CR 2032 battery with numbers facing out. To change the battery, unscrew outer cap. Illumination intensity levels will vary from bright to very low with 11 levels of brightness. The Strike Eagle riflescope uses an illuminated reticle to aid in low-light performance. When shooting at distances other than 100 yards, using good consistent shooting form and cheek weld will prevent most problems with parallax.įind out more about fixed parallax in the video below The Strike Eagle 1-6×24 riflescope is non-adjustable for parallax correction and is set from the factory to be parallax-free at 100 yards (90 meters). To change the magnification, turn the magnification ring to the desired level.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |